HYDRAULIC MOTOR: REMOVAL AND INSTALLATION.

CONVEYOR ASSEMBLY AND SUPPORT STAND: REMOVAL AND INSTALLATION (CONTINUED)

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1023

HYDRAULIC MOTOR: REMOVAL AND INSTALLATION NOTE Tag hydraulic lines for reinstallation. REMOVAL A B C D E Disconnect two motor hydraulic lines (1) from two adapters (2). Loosen setscrew (3) in coupling sprocket (4). Remove four screws (5), four flat washers (6), and four lockwashers (7) that secure motor (8) to conveyor drive-end section (9). Pull motor (8) from conveyor drive-end section (9) and coupling sprocket (4). Remove key (10) from shaft of motor (8). Remove two adapters (2), two reducers (11) and two elbows (12) from motor (8). Reverse enter of removal procedures. 12-29 Change 4 TM 9-2350-267-20

Privacy Statement
Press Release
Contact