12-18
TM 9-2350-267-20
SIDE WEAR STRIPS, BOTTOM WEAR STRIP, CHAIN RETURN WEAR STRIPS AND CHAIN GUARD, TAKE-UP END ASSEMBLY:
REMOVAL AND INSTALLATION
REMOVAL
A Remove chain assembly (TM 9-2350-267-10).
B
Remove two chain guards (1) by removing from each, four
screws (2), four lockwashers (3), four flat washers (4), four nuts
(5) and retaining strip (6).
C Remove 10 screws (7) from each side wear strip (8). Pry up and
remove side wear strips from take-up end section (9).
D Remove two screws (10), wear strip (11) and spacer (12) from
take-up end section (9).
E Remove 14 screws (13) and remove bottom wear strip (14) by
prying up wear strip from take-up end section.
INSTALLATION
A Thoroughly clean wear strip mounting surfaces of section (9)
with solvent (item 19, Appx D). Remove all particles.
B
Roughen underside of wear strips (8). Apply adhesive (item 1,
Appx D) to roughened side of wear strip and mounting surface
of section (9). Allow to dry until tacky before installation. App-
ly sealing compound (item 53, Appx D) to threads of screws (7).
C Reverse order of removal procedures.
TA310218