12-16
TM 9-2350-267-20
TAKE-UP END SECTION ASSEMBLY: REMOVAL AND INSTALLATION (CONTINUED)
G Remove three nuts (4), three lockwashers (5), three flat washers
(6) and three screws (7), that secure hinge halves (8) to takeup
end section. Allow hinges to remain attached to conveyor
center section (9).
H Raise toggle clamps (10) to release safety hooks (11) from tube
assemblies (12).
I
Remove tube assemblies (12) (p 12-20), and ball assemblies (13)
(p 12-17).
J
Remove wear strips (p 12-18).
K
Remove two pins (14) from take-up end section.
L
Remove clip (15) and pin (16). Remove rubber latch (17).
Remove two screws (18), two flat washers (19), two
lockwashers (20), and bracket (21).
M Remove take-up end section from center section.
INSTALLATION
Reverse order of removal procedures.