ROD ENDS, BALL ASSEMBLIES AND LATCH: REMOVAL AND INSTALLATION

TAKE-UP END SECTION ASSEMBLY: REMOVAL AND INSTALLATION (CONTINUED)

SIDE WEAR STRIPS, BOTTOM WEAR STRIP, CHAIN RETURN WEAR STRIPS AND CHAIN GUARD, TAKE-UP END ASSEMBLY: REMOVAL AND INSTALLATION

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1011

ROD ENDS, BALL ASSEMBLIES AND LATCH: REMOVAL AND INSTALLATION REMOVAL A Remove two nuts (1) from each rod end (2) located on each side of conveyor take-up section (3), and back off nut (4). B Remove one screw (5), one flat washer (6), and one lockwasher (7), from each of two pillow blocks (8). c Remove nut (9), flat washer (10), lockwasher (11), screw (12) and remove rod end (2) from take-up plates (13). D Back off nut (4) from rod end (2). Remove rod end (2) from take- up plates (13) and remove nut (4) from rod end (2). E Remove nut (14), lockwasher (15) and remove ball assembly (16) from each side of conveyor take-up section (3). F Remove clip (17), pin (18), and rubber latch (19) from brack- et (20). G Remove two screws (21), two flat washers (22), two lockwashers (23) and bracket (20) from take-up section (3). INSTALLATION Reverse order of removal procedures. TA310217 12-17 TM 9-2350-267-20

Privacy Statement
Press Release
Contact