REPAIR POWER CONTROL ENCLOSURE, REAR PANEL (Ml068 ONLY)

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
480

TM 9-2350-261-34 REPAIR POWER CONTROL ENCLOSURE, REAR PANEL (Ml068 ONLY) DESCRIPTION This task covers: Disassemble (page 21.134). Clean, Inspect, and Repair (see Chapter 2). Assemble (page 21.136). INITIAL SETUP TOOLS References: General Mechanic’s Tool Kit (Item 35, App B) See your -10 Materials/Parts: See your -20 Locknut (9) Equipment Conditions: Lockwasher (10) Strap Power control enclosure assembly removed bee your -20) Personnel Required: Power-Generation Equipment Repairer 52D10 DISASSEMBLE 1. 2. 3. NOTE 4. Tag all wires before disconnecting them. Remove ten screws (1), lockwashers (2), and lower faceplate (3). Discard lockwashers. 5. Remove nut (4), lockwasher (5), and lead 31A (6) from terminal A1 of relay K6 (7). 6. Remove nut (4), lockwasher (5), and leads 31.B and 31C (8) from terminal A2 of relay K 6 ( 7 ) 7. Remove nut (9), lockwasher (10), and lead 44A (11) from terminal X1 of relay K6 (7). Remove nut (9), lockwasher (10), and lead 32Q (12) from terminal X2 of relay K6 (7). Remove two screws (13), locknuts (14), four washers (15), and relay K6 (7) from rear panel (16). Discard locknuts. Remove straps (17) from leads as required. Discard straps. 21.1-34 Change 4

Privacy Statement
Press Release
Contact