TM 9-2350-261-34
89.
90.
91.
92.
On right side of earner, install new
reflector (1) and new gasket (2) on hull.
Secure with two new screws (3) and new
washers (4).
Thread leads of new stop light-tail light (5)
through new gasket (6), new spacer (7),
new gasket (6), and large mounting hole in
hull.
Install stop light-tail light (5), gasket (6),
spacer (7), and gasket (6) to hull.
From inside carrier, install existing connector
ground lead (8) under stop light-tail light
new mounting screw (9). Secure with new
washer (10) under terminal.
93.
94.
95.
96.
Install existing cable clamp (11), existing
washer (12), and new washer (13) under
stop light-tail light new mounting
screw (14).
Connect circuit 21 leads of stop light-tail
light to new wiring harness (15).
Connect circuit 22-460 lead of harness (16)
to stop light-tail light circuit 22-460-461
lead.
Connect circuits 23 and 24 to existing rear
main wiring harness (17).
21-12