INSTALL - TM-9-2350-261-34

INSTALL ENGINE COOLANT HEATER KIT - TM-9-2350-261-34_395

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
371

TM 9-2350-261-34 3. W A R N I NG D ry cleaning solvent P - D - 6 8 0 is toxic and flammable. Wear protective goggles and gloves; use only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using slovent; the flash point for type I dry cleaning solvent is 100°F (38°C) and for type II is 138°F (50 ° C). Failure to do so may result in injury or death to personnel. Clean external pipe threads of bushing (1), shutoff cock (2), elbow (3), and elbow (4) with dry cleaning solvent. 4. 5. 6. 7. 8. 9. Apply a thin, even coat of primer and then sealing compound (Item 70) to cleaned exter- nal pipe threads of bushing (1), shutoff cock (2), elbow (3), and elbow (4). Do not apply primer or sealing compound beyond small end of threads. Install bushing (1), shutoff cock (2), and elbow (3) in coolant pump (5). Install two mounting saddles (6) on mounting bracket (7). Secure with four screws (8), washers (9), and nuts (10). Install two clamps (11) in two mounting sad- dles (6). Install coolant heater (12) to two mounting saddles (6). Secure with two clamps (11). Install elbow (4) in control valve (13). 14-34

Privacy Statement
Press Release
Contact