INSTALL ENGINE COOLANT HEATER KIT - TM-9-2350-261-34

FOLLOW-THROUGH STEPS - TM-9-2350-261-34_394

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
370

TM 9-2350-261-34 INSTALL ENGINE COOLANT HEATER KIT (M106A2, M1064, AND M125A2 ONLY) INITIAL SETUP Tools: General Mechanics Tool Kit (Item 35, App B) Materials/Parts: Dry cleaning solvent (Item 18, App C) Kit P/N 12269225 (19207) Lockwasher Lockwashers (4) Lockwashers (5) Methyl isobutyl ketone (Item 46, App C) Sealing compound (Item 70, App C) Sealing compound (Item 71, App C) Sealing compound primer (Item 74, App C) Tape, glass, insulation (Item 78, App C) Personnel Required: Track Vehicle Repairer 63H10 References: See your -10 See your -20 References (cont): TM 9-6140-200-14 Equipment Conditions: Engine stopped (see your –10) Carrier blocked (see your –10) Ramp lowered (see your –10) Battery ground lead disconnected (see your -20) Driver’s power plant access panel removed (see your -20) Power plant rear access panel removed (see your -20) Trim vane lowered and power plant front access door open (see your –10) Front floor plates removed (see your –20) Power plant grill raised (see your –20) Carrier cooling system drained (see your –20) Personnel heater kit installed (page 14-2) Personnel heater removed (see your –20) INSTALL 2. Install coolant pump (5) and ground lead (6) 1. for wiring harness (7) to mounting bracket Install mounting bracket (1) on right front (1). Secure with clamp (8), two screws (9), sponson. Secure with four screws (2), flat three flat washers (10), one lockwasher (11), washers (3), and lockwashers (4). and two nuts (12). GO TO NEXT PAGE Change 2 14-33

Privacy Statement
Press Release
Contact