TM 9-2350-261-34
3.
4.
5.
Install two mounting saddles
bracket (2). Secure with four
washers (4), and nuts (5).
(1) on mounting
screws (3),
Install two clamps (6) on two mounting sad-
dles (1).
Install coolant heater (7) on two mounting
6.
7.
saddles (1). Secure with two clamps (6).
8.
9.
10.
11.
12.
13.
14.
goggles and gloves. Do not breathe
vapors. Avoid contact with skin, eyes, and
clothes. If you get dizzy while using
solvent, breathe fresh air and get medical
help. If solvent gets on hands, wash them.
If solvent gets in eyes, flush eyes with
fresh water and get medical help
immediately. Keep fire extinguisher
nearby.
Clean external tapered pipe threads of tee
(8), two shutoff cocks (9 and 10), three bush-
ings (11, 12, and 13), and four elbows (14,
15, 16, and 17) with dry cleaning solvent.
15. Install
(14).
16. Install
W A R N I N G
Dry
cleaning
solvent
P - D - 6 8 0 is
toxic
and
flammable. Always use in
an open area with good air
flow, away from sparks,
h e a t , o r f l a m e s . W e ar
Apply a thin, even coat of primer and then
sealing compound (Item 70) to cleaned exter-
nal tapered pipe threads of tee (8), two
shutoff cocks (9 and 10), three bushings (11,
12, and 13), and four elbows (14, 15, 16,
and 17). Do not apply primer or sealing
compound beyond small end of tapered
threads.
Install bushing (11), shutoff cock (9), and
elbow (14) in coolant pump (18).
Install elbow (15) on control valve (19).
Install tee (8) in coolant heater (7).
Install bushing (12) in tee (8).
Install shutoff cock (10) in bushing (12).
Install bushing (13) in tee (8).
Install elbow (16) in bushing (13).
hose (20) and clamp (21) on elbow
elbow (17) in coolant heater (7).
GO TO NEXT PAGE
14-3
