INSTALL ENGINE COOLANT HEATER KIT (M113A2, M741A1, M901A1, AND M1059 ONLY)

C H A P T E R 14 E N G I N E C O O L A N T H E A T E R K I T

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
339

TM 9-2350-261-34 INSTALL ENGINE COOLANT HEATER KIT (M113A2, M741A1, M901A1, AND M1059 ONLY) INITIAL SETUP Tools: General Mechanics Tool Kit (Item 35, App B) Materials/Parts: Dry cleaning solvent (Item 18, App C) Kit P/N 12349820 (19207) Lockwasher Lockwashers (4) Lockwashers (8) Methyl isobutyl ketone (Item 46, App C) Sealing compound (Item 70, App C) Sealing compound (Item 71, App C) Sealing compound primer (Item 74, App C) Tape, glass, insulation (Item 78, App C) Personnel Required: Track Vehicle Repairer 63H10 References: See your -10 See your -20 References (cont): TM 9-6140-200-14 Equipment Conditions Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (see your -20) Driver’s power plant access panel removed (see your -20) Power plant rear access panel removed (see your -20) Trim vane lowered and power plant front access door opened (see your -10) Rear and right front floor plates removed (see your -20) Power plant grill raised (see your -20) Carrier cooling system drained (see your -20) Personnel heater kit installed (page 14-2) Personnel heater removed (see your -20) INSTALL N O T E Fuel hoses used on the engine coolant heater installation are the flareless type. If it is necessary to replace hose, the connection fittings must also be replaced. 1. Install mounting bracket (1) on right front sponson. Secure with four screws (2), washers (3), and Iockwashers (4). 2. Install coolant pump (5) and ground lead (6) for wiring harness (7) on mounting bracket (1). Secure with clamp (8), two screws (9), three washers (10), one lockwasher (11), and two nuts (12). 14-2

Privacy Statement
Press Release
Contact