71. Thread personnel heater wiring harness (1)
through transverse beam from driver’s
compartment into personnel compartment.
72. Connect personnel heater wiring harness (1)
to control box (2).
73. Connect personnel heater wiring harness (1)
to personnel heater (3).
74. Install shell (4) and washer (5) on control
box lead (6).
75. Connect circuit 400 lead (7) of rear main
wiring harness (8) to control box lead (6).
TM 9-2350-261-34
76. Connect circuit 402 lead (9) of rear main
wiring harness (8) to fuel pump lead (10)
and to connector (11) of personnel heater
wiring harness (1).
77. Remove clip (12) securing battery cable (13)
and radio cable (14) to cradle (15). Discard
clip.
78. Remove screw (16) and cradle (15) from
weldnut (17). Discard cradle.
79. Install clamp (18) on battery cable (13),
radio cable (14), and personnel heater wiring
harness (1).
80. Secure personnel heater wiring harness
ground lead (19) and clamp (18) to
weldnut (17) with retained screw (16),
lockwasher (20) and flat washer (21).
11-13
GO TO NEXT PAGE
