SPECIAL PURPOSE CABLE FOR POWER CONTROL ENCLOSURE

S e c t i o n I I I . G E N E R A L M A I N T E N A N C E I N S T R U C T I O N S

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
7

TM 9-2350-261-34 SPECIAL PURPOSE CABLE FOR POWER CONTROL ENCLOSURE Make a special electrical cable to plug in from a shop wall socket to the Power Control Enclosure for powering up the Power Control Enclosure while on a shop table, the purpose is to preform troubleshooting or testing after repairs have been made. Use a W3 harness (To be modified) Part Number 12383899, See TM 9-2350-261-24P. CAUTION When installing wires into the plug, ensure polarity is correct, incorrect polarity can cause damage to equipment and harm per- sonnel when electrical power is applied to the Power Control Enclosure. MODIFYING W3 HARNESS FOR USING WITH POWER CONTROL ENCLOSURE Remove connector labeled W3P1 (A3J1) from W3 harness and replace with new plug Part Number WC596-13-3(81348) NSN 5935-01-005-3579. (USE WIRING DIAGRAM) The length of the special purpose cable is dependent upon the Enclosure will be on. A W3 cable is distance of the wall socket and the work bench the Power Control between 115 and 125 inches long. W3 CABLE - PART NUMBER 12383899 Figure f(1)a. Special Purpose Cable Change 3 2-6.1 f(1).

Privacy Statement
Press Release
Contact