I N S T A L L - TM-9-2350-261-34

R E P L A C E T R A N S F E R G E A R C A S E P U L L E Y ( 2 0 0 A MP G E N E R A T O R O N L Y)

R E M O V E / I N S T A L L T R A N S F E R G E A R C A S E

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
105

TM9-2350-261-34 I N S T A L L 5. 6. 7. 8. 9. Install new seal (1) on drive bearing plate (2). Install snap ring (3), two retaining rings (4), two bearings (5) and spacer (6) on drive bearing plate (2). Use retaining ring pliers and snap ring pliers. Install plug (7) and drive pulley (8) on drive bearing plate (2). C A U T I O N Align oil hole in housing with oil hole in case. Install new preformed packing (9) and shim ( 10) in transfer gearcase ( 11). Align drive pulley assembly on transfer gearcase (11). Secure with four new key washers (12) and cap screws (13). Tighten screws to 252–300 lb-in (28-33 N.m) torque. Use torque wrench. FOLLOW-THROUGH STEPS 1. Install generator drive belt (see your –20). END OF TASK 3-17

Privacy Statement
Press Release
Contact