TM9-2350-261-34
R E P L A C E T R A N S F E R G E A R C A S E P U L L E Y ( 2 0 0 A MP
G E N E R A T O R O N L Y)
DESCRIPTION
This task covers:
Remove (page 3-16).
Install (page3-17).
INITIAL SETUP
Tools:
Personnel Required:
General Mechanics Tool Kit (Item 35, App B)
Track Vehicle Repairer 63H10
Retaining Ring Pliers (Item 64, App B)
Snap Ring Pliers (Item 69, App B)
References:
Torque Wrench (Item 117, App B)
See your -10
Materials/Parts:
See your -20
Key washer (1)
Equipment Conditions:
Preformed packing
Generator drive belt removed (see your -20 )
seal
REMOVE
1. Remove four cap screws ( 1 ) and key washers
(2) from drive pulley assembly and transfer
gearcase (3). Separate drive pulley assembly
from transfer gearcase. Discard key washers.
2. Remove shim (4) and preformed packing (5)
from transfer gearcase (3). Discard packing.
3. Remove plug (6). drive pulley (7) and seal (8)
from drive bearing plate (9). Discard seal.
4. Remove snap ring ( 10), two retaining rings
(11), bearings (12) and spacer ( 13) from drive
bearing plate (9). Use retaining ring pliers
and snap ring pliers.
3-16
