TM 9-2350-261-34
Apply a thin coat of antiseize compound to
cleaned t breads of two screws ( 1 ).
Install crossshaft bracket (2) on
transmission. Secure with two screws ( 1 )
and new key washers (3).
Apply a thin, even coat of primer and then
sealing compound to cleaned external threads
of vent tube elbow (4). Do not apply primer
or sealing compound beyond small end of
threads.
10. Install vent tube elbow (4) in transmission.
11. Connect vent tube (5) to vent tube
elbow ( 4 ) .
12.
13.
14.
15.
Apply a thin, even coat of primer and then
sealing compound to cleaned external threads
of elbows (6). Do not apply primer or
sealing compound beyond small end of
threads.
Install two new packings (7) and elbows (6)
in transmission.
Position range selector arm (8) on transmis-
sion shaft (9) with offset side of arm toward
transmission and clamping screw hole
aligned with flat on shaft. Secure with
screw (10) and nut (11).
Position throttle valve arm (12) on trans-
mission shaft ( 9 ) with offset side of arm
away from transmission and clamping screw
hole aligned with flat on shaft. Secure with
screw ( 13) and new locknut ( 14).
FOLLOW-THROUGH STEPS
1. Install transmission on transfer gearcase
2. Install power plant in carrier (see your 20).
(page 3-4 ).
3. Fill transmission (see your LO).
END OF TASK
3-15
I N S T A L L
7.
8.
9 .