TM 9-2350-261-20-2
INSTALL
5. Install new inner seal (1) on support arm
pin (2).
NOTE
Exercise new shock absorber to the fully
extended position and move shock ab-
sorber back and forth several times until
resistance can be felt throughout the
entire length of the stroke.
Make sure shock absorber is installed
with large end of bearing installed first.
6.
7.
Install shock absorber (3), new outer
seal (4), and shoulder washer (5) on support
arm pin (2).
Install new inner seal (1), shock
absorber (3), new outer seal (4), and
shoulder washer (5) on hull bracket (6).
N O T E
M741A1 does not have Items (1), (4), and
(5) at top of shock absorber. Install shock
absorber (3), bearing (7), and washer (8)
on hull bracket (6).
8. Secure shock absorber (3) with two nuts (9).
9. Tighten two nuts (9) to 60-80 lb-ft
(8-11 N·m) torque. Use torque wrench. Se-
cure with new cotter pins (10).
FOLLOW-THROUGH STEPS
1. Install road wheel (page 22-7).
3. Road test carrier (page 2-91) to check that
shock absorber is installed properly.
2. Install track shroud and covers (page 22–2).
END OF TASK
Change 1
22-27
