CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2

R E P L A C E B A T T E R Y D R A W E R I N S U L A T I O N A N D H E A T E X C H A N G E R ( M 1 0 6 A 2 , M 1 2 5 A 2 , A N D M 1 0 6 4 O N L Y)

CLEAN, INSPECT, AND REPAIR (cont)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
326

6. If damaged, remove two insulation sheets (1) and two insulation strips (2) from battery drawer (3). CLEAN, INSPECT, AND REPAIR 7. 8. 9. Clean heat exchanger plate with brush dipped in mixture of sodium bicarbonate. After foaming stops, flush with clean water and dry. Check heat exchanger. Replace bent or cracked heat exchanger. Check insulation. Replace loose, missing, or damaged strip or sheets. INSTALL 10. 11. 12. 13. Apply adhesive on insulation sheets. Wait 10-20 seconds until adhesive becomes tacky. If removed, install two insulation strips (2) and two insulation sheets (1) on battery drawer (3). If removed, install left insulation sheet (4), right insulation sheet (5), rear insulation sheet (6), bottom insulation sheet (7), and top insulation sheet (8) in battery drawer shield (9). Place two clamps (10) on heat exchanger (11). Install heat exchanger in battery drawer (3). 14. 15. 16. TM 9-2350-261-20-2 Install battery drawer (page 13-23). Place two clamps (10) on Install two hoses (13) on and heat exchanger (11). clamps. two elbows (12). two elbows (12) Secure with four Place two brackets (14) on battery drawer (3). Secure with four screws (15), washers (1), and nuts (2). GO TO NEXT PAGE 13-33

Privacy Statement
Press Release
Contact