TM 9-2350-261-20-2 5. If damaged, remove front insulation sheet(1), rear insulation sheet (2), rightinsulation sheet (3), left insulation sheet (4),and bottom insulation sheet (5) from batterybox (6).CLEAN, INSPECT, AND REPAIR6.7.8.Clean heat exchanger plate with brushdipped in mixture of sodium bicarbonate andwater. After foaming stops, flush with cleanwater and dry.Check heat exchanger. Replace bent orcracked heat exchanger.Check insulation. Replace loose, missing, ordamaged strip or sheets.INSTALL9.10.11.12.Apply adhesive on insulation sheets. Wait10-20 seconds until adhesive becomes tacky.If removed, install bottom insulationsheet (5), left insulation sheet (4), rightinsulation sheet (3), rear insulation sheet(2), and front insulation sheet (1) in batterybox (6).If removed, install insulation sheet (7) onbattery box cover (8).Install two new grommets (9) in batterybox (6).13.14.15.Place two clamps(11). Install heatbox (6).Install two short(10) on heat exchangerexchanger in batteryhoses (12) on heatexchanger (11). Secure with twoclamps (10).Place four clamps (13) on two elbows14).Install elbows in hoses (12). Installhoses (15) on elbows. Secure all hosesclamps (13).withFOLLOW-THROUGH STEPS 1. Fill carrier cooling system (page 8-5).4. Raise and lock ramp (see your -10).2. Fill coolant heater system (page 32-10).5. Turn MASTER SWITCH OFF (see your -10).3. Start coolant heater (see your -10). Check for6. Install batteries (page 13-16)leaks.END OF TASK13-36Change 3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
