T M84.85.86.87.9-230-261-20-2Install rear main wiring harness (1) onguard (2). Secure with two screws (3), nuts(4), and clamps (5).Install guard (2) and ground strap (6) onhull. Secure with two screws (7) and newlockwashers (S).Install wiring harness (1) on cradle (9). Se-cure with cradle clip (10).Install wiring harness (1) on fuel tube (11).88.89.90.91.92.93.94.If engine coolant heater is installed, connectcircuit 402A lead (13) to engine coolantheater fuel pump (14).-If personnel heater is installed, connect cir-cuit 402 lead (15 ) to personnel heater fuelpump (16).Install circuit 451 lead ( 17) on two cradles(18). Secure with two cradle clips (19).Install circuit 451 lead ( 17) on weldnut (20).Secure with screw (21), new lockwasher(22), and clamp (23).Install clamp (24) on circuit 451 lead (17).Secure with screw (25) and nut (26).Install clamp (24) on floor transverse beam(27). Secure with two screws (28) andnuts (29).Install wiring harness (30) and bilge tubeclamp (31) on weldnut (32). Secure withscrew (33) and clamp (34).12-128secure with two straps(12).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business