72.73.74.75.76,77.78.79.Install rear main wiring harness (1) on sev-en cradles (2). Secure with seven cradleclips (3).If engine coolant heater is installed, connectcircuit 402A lead (4) to engine coolant heat-er wiring harness and circuit 400A lead (5)to engine coolant heater control box.If personnel heater is installed, connect cir-cuit 402 lead (6) to personnel heater wiringharness and circuit 400 lead (7) to personnelheater control box.Connect circuit 38 lead (8) to front domelight (9).Install wiring harness (1) on weldnut (10).Secure with screw (11) and clamp (12).Install wiring harness (1) on two cradles(13). Secure with two cradle clips (14).Install circuit 28 lead (15) in clamp (16).Secure with screw (17).Connect circuit 28 lead (15) to fuel quantity80.81.82.83.TM 9-2350-261-20-2Install three leads (19, 20, and 21) throughnut (22), bushing (23), and connector (24).Tighten nut on connector.Install three new terminals (25), insulators(26), and connectors (27) on the ends ofthree leads installed in step 86.Connect circuits 24, 22, and 21 leads(21, 20, and 19) to left tail light (28).Install left tail light (28) and guard (29) onhull. Secure with four screws (30) and newlockwashers (31).GO TO NEXT PAGE12-127sending unit (18).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
