TM 9-2350-261-20-2
R E P L A C E S T A R T E R G R O U N D L E A D S
DESCRIPTION
This task covers:
Remove (page 10-4).
Clean, Inspect, and Replace (page 10-5).
Install (page 10-5).
INITIAL SETUP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
see your -lo
Materials/Parts:
Equipment Conditions:
Leads, as required
Engine stopped/shutdown (see your -10)
Self-locking nut
Carrier blocked (see your -10)
Trim vane lowered (see your -10)
Personnel Required:
Power plant front access door open
Unit Mechanic
(see your -lo)
Battery ground leads disconnected (page 13-2)
REMOVE
1.
2.
3.
Remove nut (1), washer (2), short ground
lead (3), and long ground lead (4) from
starter (5).
N O T E
Some earner hull grounds may have star
washers. Discard star washers and
assemble ground leads with flat washers
as instructed in the installation steps.
Remove screw (6), washer (7), and short lead
(3) from engine block. Remove lead from
earner.
Remove locknut (8), long lead (4), two
washers (9), and screw (10) from hull mount.
Remove lead from carrier. Discard locknut.
10-4
