TM 9-2350-261-20-24. Remove three bolts (1), lockwashers (2),starter (3) with solenoid (4), and gasket (5)(if installed) from engine (6). Discardlockwashers.CLEAN, INSPECT, AND REPAIR5. Check starter drive teeth. Remove burs. Re-place starter that has damaged teeth orteeth worn beyond original shape.NOTECheck that starter-to-engine housinggasket is in place. Gasket is necessary tokeep water out of starter.I N S T A LL6. Install gasket (5) on engine (6).7. Place starter (3) with solenoid (4) on engine(6). Secure with three new lockwashers (2)and three bolts (1). Tighten screws to137-147 lb-ft (186-199 N•m) torque. Usetorque wrench.8. Install two new lo&washers (7) (Delco andLeece Neville only) and circuit 74A lead (8)on terminal of starter solenoid (4). Securewith nut (9) (screw on Prestolite).9. Install new lockwasher (10) and circuit 6lead (11) on terminal of solenoid (4). Securewith nut (12).10. Install new lockwasher (13) and two groundleads (14) on terminal of starter (3). Securewith nut (15).11. Go to follow-through steps (items 1 thru 4)(page 10-2.3).GO TO NEXT PAGEChange 410-2.1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business