TM 9-2350-261-20-2R E P L A C E S T A R T E RDESCRIPTIONThis task covers: Remove (page 10-2).Clean, Inspect, and Repair (page 10-2.1).Install (page 10-2.1).Alternate Remove Method (10-2.2).Alternate InstallMethod (10-2.3).I N I T I A L S E T U PTools:General Mechanics Tool Kit Item 30, App D)Torque Wrench (Item 96, App D)Steel rods (2) (Item 59.1, App D)Materials/PartsGasketLockwasher (3)Lockwasher (4)Personnel Required:Unit MechanicHelper (H)References:See your -10Equipment Conditions:Engine stopped/shutdown (see your -10)Carrier blocked (See your -10) *if alternatemethod is usedBattery ground leads disconnected (page 13-2)Power plant removed (page 5-12) (if rods arenot available)Trim vane lowered (See your -10) *Power plant front access (See your -10) *Door opened and right side exhaust piperemoved (page 7-16) *R E M O V ENOTEIf power plant is in vehicle and steel rodsare available, go to step 12 to usealternative method. A helper is needed.1. Remove nut (1), lockwasher (2), and twoground leads (3) from terminal on starter (4).Discard lockwasher.2. Remove nut (5), lockwasher (6), and circuit 6lead (7) from terminal on starter solenoid (8).Discard lockwasher.10-2Change 43. Remove nut (9) (screw on Prestolite), twolockwashers (10) (Delco and Leece Nevilleonly) and circuit 74A lead (11) from terminalon solenoid (8). Discard lockwashers.WARNINGAvoid injury.G e t a nassistant to help you lift thestarter or use a hoist.Starter weighs about 75pounds (34 kg).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business