TM 9-2350-261-20-215.16.17.Coat threads of three screws (1) with anti-seize compound.Install bracket (2) on transfer gearcase.Secure with two new key washers (3), flatwasher (4), new lockwasher (5), and threescrews (1). Bend tabs on key washers (3).Screw jam nut (6) on rod end (7). Installrod ends (7 and 8) in turnbuckle (9).N O T EUse straightedge across face of both pul-leys to assist in proper alignment.18. To obtain correct alignment, adjust theposition of the generator mounting bracket(10) before you tighten the screws (11) inthe slotted holes. Align pulley (12), ongenerator (13), with drive pulley (14), onthe transfer gearcase, to within 1/8 inch,then tighten nuts on screws (11).19.20.21.Place spacer (15) and rod end (7) on bracket(2). Secure with screw (16) and newlocknut (17) .Place spacer (18) and rod end (8) on genera-tor (13). Secure with screw (19) and newlocknut (20).Connect cable (21) to generator (13).FOLLOW-THROUGH STEPS1. Connect battery ground lead (page 13-2).3. Check output of generator (page 3-2).2. Install generator drive belts (page 9-29).4. Stop/shutdown engine (see your -10).5. Install power plant rear access panels andsupport (page 24-27).END OF TASK9 - 3 3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business