Support generator (l). Remove two locknuts
(2), washers (3), Screw (4), screw (5), and
generator (1) from mounting bracket (6).
Discard locknuts.
Remove four locknuts (7), screws (8), two
straps (9), and bracket (6) from engine.
Discard locknuts.
NOTE
If replacing generator, do steps 8
through 10.
s.
9
. .
10.
Remove three screws (10) and washers (11)
that secure pulley (12) and bushing (13) to
generator shaft (14).
Use three screws (10) to separate pulley
(12) and bushing (13). (Install three screws
in three threaded holes of pulley. Tighten
screws until you are able to separate pulley
from bushing. )
Remove pulley ( 12) and bushing (13) from
generator shaft (14). Remove key (15) from
generator shaft.
INSTALL
NOTE
If installing new generator, begin with
step 11, but remove nut and washer from
generator shaft before installing pulley.
Nut and washer are not used. If not
installing new generator go to step 13.
11.
12.
13.
14.
Install key (15) on generator shaft (14). In-
stall bushing (13 ) and pulley (12) on genera-
tor shaft.
Secure bushing (13) and pulley (12) to gen-
erator shaft (14 ) with three washers (11)
and screws ( 10). Alternately tighten screws.
Torque screws to 73-79 lb-in (8.2-8.9 N-m).
Use torque wrench and socket wrench set.
Place bracket (6) on engine. Secure with two
straps (9), four screws (8), and new
locknuts (7). Do not tighten.
Install generator (1) on bracket (6). Secure
with screw (5), screw (4), two washers (3),
and new locknuts (2).
9-32
T M 9 - 2 3 5 0 - 2 6 1 - 2 0 - 2
6 .
7 .