TM 9-2350-261-20-1
7. Push
a. If
to
b.
If
VTM circuit breaker to ON.
display reads (8888) and (- -- -), go
step 8.
display is not blank, but does not read
(8888) and (- - - -), write up DA form
2404 on faulty VTM display. Report
problem to supervisor.
c. If display is blank, go to VTM blank
display diagnostic troubleshooting
(see TM 9-4910-571-12&P).
8. Perform VTM confidence check
(see TM 9-4910-571-12&P). If VTM
confidence check does not pass, go to
STE/ICE confidence test fault isolation
(see TM 9-4910-571-12&P).
9. Select test 60, then press and release TEST
button.
10.
11.
12.
Enter earner VID (03) into VTM, then
press and release TEST button.
Select test 61, then press and release TEST
button. If earner VID (03) does not appear
on VTM display,
(see-TM 9-4910-571-12&P).
Return to troubleshooting.
13.
14.
15.
16.
Pull VTM circuit breaker to OFF.
Remove power cable W5 from batteries and
VTM. Use electrical connector pliers.
Install battery cover. See CHECK CARRIER
BATTERIES in your -10.
Stow VTM and power cable W5 in transit
case.
END OF TASK
3-276
Change 1
R E M O V E