TM 9-2350-261-20-1
HOOK UP/REMOVE STE/ICE-R TEST SET FOR TEST NUMBERS
72 THRU 75
INITIAL SETUP
Tools:
STE/ICE-R Test Set (Item 71.1, App D)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped (see your -10)
Carrier blocked (see your -10)
All electrical accessories turned off
(see your -10)
Engine at operating temperature
(see your -10)
Fuel off, engine must not start (see your -10)
STE/ICE-R power hooked up (page 3-275)
HOOK UP
6.
1.
2.
3.
4.
5.
NOTE
Do not have battery charger connected
when performing test numbers 72 thru 75.
Remove transducer cable W4 and current
probe from transit case.
Pull VTM circuit breaker to OFF.
Install cable W4P1 (1) on VTM
jack J3 TK (2).
Attach cable W4P2 (3) to current probe (4).
Push VTM circuit breaker to ON.
7.
Remove battery cover. See CHECK CARRIER
BATTERIES in your -10.
For test numbers 72 or 74, current probe (4)
is connected to positive cable (5) between
battery (6) and starter (7). Point arrow on
current probe along cable to starter. Make
sure current probe is closed.
GO TO NEXT PAGE
Change 1
3-281
