HOOK UP/REMOVE STE/ICE-R FOR STARTER CIRCUIT TESTS

H O O K U P / R E M O V E S T E / I C E - R F O R E N G I N E R P M ...CONT.

HOOK UP/REMOVE STE/ICE-R FOR STARTER CIRCUIT TESTS CONT.

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
599

TM 9-2350-261-20-1 HOOK UP/REMOVE STE/ICE-R FOR STARTER CIRCUIT TESTS INITIAL SETUP Tools: STE/ICE-R Test Set (Item 71.1, App D) Personnel Required: Unit Mechanic References: See your -10 References (cont): TM 9-4910-571-12&P Equipment Conditions: Engine stopped (see your -10) Carrier blocked (see your -10) STE/ICE-R power hooked up (page 3-275) HOOK UP NOTE 1. 2. 3. 4. Remove transducer cable W4 from transit case. Pull VTM circuit breaker to OFF. If current probe is below room temper- ature, wait at least 5 minutes after con- necting probe to VTM before doing offset test, or perform offset within 30 seconds of starting each measurement. Install cable W4P1 (1) on VTM jack J3 TK (2). 5. Attach cable W4P2 (3) to current probe (4). Clamp current probe (4) around positive (+) battery cable (5) going to the starter (6). Point arrow on probe along cable to starter. Make sure probe is closed. GO TO NEXT PAGE Change 4 3-279

Privacy Statement
Press Release
Contact