TM 9-2350-247-20-2
REPLACE PIVOT STEERING BRAKE LINING (M548A1)
THIS WORK PACKAGE COVERS:
Removal (page 0375 00-1).
Inspection-Acceptance and Rejection Criteria (page 0375 00-1).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
Equipment Condition
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Engine stopped (see your -10)
Personnel Required
Carrier blocked (see your -10)
Unit Mechanic
Pivot steering brake removed (WP 0373 00)
REMOVAL
NOTE
Some brake linings have two clips and rivets.
1.
Remove brake lining (1) from piston (2) in housing (3).
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
1.
Inspect brake lining material. If worn down to rivets, if only 1/8 inch (.32 cm) material is left on rivet, or if worn down
until any wear grooves are gone, replace brake lining.
