TM 9-2350-247-20-2
REPLACE PIVOT STEERING CLUTCH DISK (M548A1)
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Maintenance Level
References
See your -10
Unit
Equipment Condition
Tools and Special Tools
Engine stopped (see your -10)
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Carrier blocked (see your -10)
Torque Wrench (WP 0541 00, Item 69)
Right and left center seat floor plates raised
(WP 0394 00)
Materials/Parts
Throttle floor plate removed (WP 0394 00)
Lock nut (8)
Cab left floor plate removed (WP 0394 00)
Personnel Required
Propeller shafts and universal joints removed
Unit Mechanic
REMOVAL
1.
Remove eight lock nuts (1), two adapters (2), and clutch disks (3) from four differential studs (4). Discard lock nuts.
INSTALLATION
1.
Place two clutch disks (3) and adapters (2) on four differential studs (4). Secure with eight new lock nuts (1). Tighten
lock nuts to 75 to 80 lb-ft (102 to 108 Nm) torque.