TM 9-2350-247-20-2
REPLACE TOWING EYE AND HOOK
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Equipment Condition
Torque Wrench (WP 0541 00, Item 69)
Engine stopped (see your -10)
Personnel Required
Unit Mechanic
Carrier blocked (see your -10)
REMOVAL
NOTE
There are four towing eyes on the carrier, two in front and two in the rear. Clip, pin, and hook
are installed on front towing eyes only.
1.
Remove clip (1) and pin (2) that secure hook (3) in towing eye (4). Remove hook.
2.
Remove six screws (5) that secure towing eye (4) to carrier. Remove eye.
INSTALLATION
1.
Place towing eye (4) on carrier. Secure with six screws (5). Tighten screws to 130-140 lb-ft (176-190 Nm) torque.
2.
Install hook (3) in towing eye (4). Secure with pin (2) and clip (1).
END OF TASK