TM 9-2350-247-20-2
ADJUST THROTTLE PEDAL TO FULL THROTTLE AND IDLE POSITIONS (M548A1) --
0199 00
Continued
NOTE
Adjustment is needed only after disassembly and assembly.
4.
Adjust detent plunger as follows:
a.
Loosen two jam nuts (9) securing two detent adjusting screws (10).
b.
Turn two detent adjusting screws (10) right to increase pressure or left to decrease pressure. A force of 35 to 40 lb
(16 to 18 kg) is needed to depress detent plunger (11).
c.
Secure two jam nuts (9) on two detent adjusting screws (10).
FOLLOW-THROUGH STEPS
1.
Start engine (see your -10).
2.
Check throttle pedal linkage for proper operation. If it fails to work properly, readjust.
3.
Stop engine (see your -10).
4.
Lower left center seat floor plate (WP 0394 00).
5.
Lower center seat (see your -10).
END OF TASK
0199 00-6
