TM 9-2350-247-20-2
ADJUST ACCELERATOR LINKAGE (M548A3) -- Continued
0200 00
ADJUSTMENT FOR FULL THROTTLE
1.
Loosen pedal toe stop screw (1) and jam nut (2).
2.
(H) Press accelerator pedal (3) until edge of connector pin (4) is 1/32 to 1/16 inch (1 to 1.5 mm) away from washer (5).
Adjust pedal toe stop screw (1) and tighten jam nut (2).
FOLLOW-THROUGH STEPS
1.
Start engine and check for proper idle and full power (see your -10).
2.
Stop engine (see your -10).
3.
Lower center seat (see your -10).
4.
Install left center floor plate (WP 0395 00).
5.
Install bottom access cover (see your -10).
6.
Install power plant rear access panel (see your -10).
END OF TASK