7-75. DRIVERS BULKHEAD TO ENGINE DISCONNECT STE/lCE WIRING HARNESS (12329994) REPLACEMENT

b. INSTALLATION - TM-9-2350-287-20-1_926

DRIVERS BULKHEAD TO ENGINE DISCONNECT STE/lCE WIRING HARNESS (12329994) REPLACEMENT (continued)

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
899

TM 9-2350-287-20-1 7-75. DRIVER’S BULKHEAD TO ENGINE DISCONNECT STE/lCE WIRING HARNESS (12329994) REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Equipment Conditions: l General mechanic’s tool kit (Item 24, l Vehicle parked on Ievel ground (refer to Appendix l) TM 9-2350-287-10). l MASTER switch set to OFF (refer to Materials/Parts: TM 9-2350-287-10). l Lockwasher (Item 131, Appendix H) l Driver's hatch cover opened and secured l Lockwasher (2) (Item 148, Appendix H) (refer to TM 9-2350-287-10). l Lockwasher (4) (Item 172, Appendix H) l Battery ground cables disconnected l Lockwasher (3) (Item 175, Appendix H) (para 7-41). Personnel Required: Two a. REMOVAL 1. Disconnect connector (9) from driver’s bulkhead receptacle (6). . 2. Remove four screws (1), washers (2), Iockwashers (3), and nuts (4), gasket (7), STE/ICE wiring harness (5), and bulkhead receptacle (6) from engine disconnect (8). Discard Iockwashers. 3. Remove two screws (13), Iockwashers (1 2), and current shunt lead BB (11) and current shunt lead from shunt (14). Discard Iockwashers. 4. Remove screw (16), two washers (17) ground cable 7 (18), and ground lead W (10) from chassis BA (15) ground 7-229 connection (19). Reinstall screw (16), ground cable 7 (18) and washers (17).

Privacy Statement
Press Release
Contact