7-73. TRAILER RECEPTACLE AND CABLE ASSEMBLY (12330246) REPLACEMENT

7-72. INTERVEHICULAR GROUNDING CABLE AND STOWAGE STRAPS REPLACEMENT

b. INSTALLATION - TM-9-2350-287-20-1_923

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
894

TM 9-2350-287-20-1 7-73. TRAILER RECEPTACLE AND CABLE ASSEMBLY (12330246) REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Equipment Conditions: General mechanic's tool kit (Item 24, Vehicle parked on level ground (refer to Appendix I) TM 9-2350-287-10). MASTER switch set to OFF (refer to Materials/Parts: TM 9-2350-287-10). Tape, insulation, electrical (Item 67, Appendix D) Battery ground cables disconnected (para 7-41). Gasket (Item 96, Appendix H) APU control box removed (para 7-22). Lockwasher (2) (Item 136, Appendix H) Lockwasher (6) (Item 175, Appendix H) a. REMOVAL 1. Disconnect five connectors (9) from harness 12330252 connectors (8). 2. Disconnect two cable assembly ground lugs (6) from vehicle mounting studs by removing screw (7) and two lockwashers (5). Discard lockwashers. NOTE Do not remove other wiring harnesses from straps. Install hardware after wiring harness straps have been removed. 3. Remove two wiring harness straps (1) by removing screw (4), lockwasher (3), and washer (2) from each strap (1). Discard lockwashers. 4. Remove four screws (14) and lockwashers (13) and receptacle cover (15) from trailer receptacle (10). Discard lockwashers. 5. Pull receptacle (10), gasket (12), and cable assembly (11) from rear of vehicle. 6. Remove gasket (12) from receptacle (10). Discard gasket. [Text Deleted] Change 1 7-224

Privacy Statement
Press Release
Contact