TM 9-2350-287-20-1
7-55. BATTERY TO DRIVER’S BULKHEAD WIRING HARNESS (12330317) REPLACEMENT
(continued).
2.
Disconnect harness 12330256 plug (10) from connector (18) at driver’s side of bulkhead (17).
NOTE
An assistant is needed when removing screws from cable and STE/ICE leads.
Remove four screws (11 ), washers (1 4), Iockwashers (15), and nuts (1 6), gasket (1 2), and cable receptacle
3.
b.
1.
2.
3.
(13) from driver’s
INSTALLATION
compartment bulkhead (17). Discard Iockwashers.
Install cable receptacle (13) in driver’s compartment bulkhead (17) using gasket (12) and four nuts (1 6), new
Iockwashers (15), washers (14), and screws (11).
Connect harness 12330256 plug (10) toconnector (18) at driver’s side of bulkhead (17).
Install cable 49 (8), STE/lCE lead 10-R (6), cable 62 (5), cable 81 (3), STE/lCE lead 10-V (4), and cable 2B
(2) on battery terminal (9) with screw (7) and nut (1).
FOLLOW-ON MAINTENANCE:
• Connect battery ground cables (para 7-41).
7-166
