TM 9-2350-287-20-1
7-53. POWERPACK WIRING HARNESS MOUNTING BRACKET REPLACEMENT.
7his Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic's tool kit
(Item 24, Appendix 1)
• Torque wrench, O-175 ft-lb
(Item 69, Appendix 1)
Materials/Parts:
l Lockwasher (2) (Item 164, Appendix H)
• Lockwasher (12) (Item 173, Appendix H)
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
l Transmission access doors opened (refer
to TM 9-2350-287-10).
l Battery ground cables disconnected (para 7-41).
a.
REMOVAL
1.
Disconnect three wiring harnesses (9, 10, and 12)
from three electrical receptacles (5, 8, and 14) on
powerpack wiring harness mounting bracket (13).
NOTE
For proper installation, mark location of each
receptacle in mounting bracket.
2.
Remove 12 screws (4), washers (3), Iockwashers (2),
and nuts (1) and three electrical receptacles (5,8, and
14) from bracket (13). Discard Iockwashers.
3.
Remove two screws (6) and Iockwashers (7) and
bracket (13) from transmission (11). Discard
Iockwashers.
7-161
