7-56. BULKHEAD TO DRIVERS PORTABLE INSTRUMENT PANEL WIRING HARNESS (12260287) REPLACEMENT.

b. INSTALLATION - TM-9-2350-287-20-1_864

BULKHEAD TO DRIVERS PORTABLE INSTRUMENT PANEL WIRING HARNESS (12260287) REPLACEMENT (continued). - TM-9-2350-287-20-1_866

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
837

7-56. BULKHEAD TO DRIVER’S PORTABLE INSTRUMENT PANEL WIRING HARNESS (12260287) REPLACEMENT. 7his Task Covers: a. Removal b. Installation Initial Setup: Tool/test Equipment: •General mechanic's tool kit (Item 24, Appendix 1) Materials/Parts: •Lockwasher (Item 122, Appendix H) • Lockwasher (4) (Item 173, Appendix H) •Lockwasher (4) (Item 175, Appendix H) Equipment Conditions: •Vehicle parked on level ground (refer to TM 9-2350-287-10). • Battery ground cables disconnected (para 7-41). (para 7-6). •MASTER switch set to OFF (refer to TM 9-2350-287-10). a. REMOVAL 1. Remove four screws (8), washers (3), Iockwashers (4), nuts (5), ground strap (6), Iockwasher (7), and harness connector No. 12260287 (2) from bulkhead connector (1). Discard Iockwashers. 2. Disconnect connector (9) from bulkhead connector (1 O). 3. Remove two screws (14), Iockwashers (13), and washers (12) from two retaining straps (11). Remove wiring harness connector No. 12260287 (2) from retaining straps (11 ). Discard Iockwashers. 4. Disconnect wire connector No. 459A (15) and 509E (1 6). TM 9-2350-287-20-1 • Driver's portable insrument panel removed 7-167

Privacy Statement
Press Release
Contact