TM 9-2350-287-20-1
7-56. BULKHEAD TO DRIVER’S PORTABLE INSTRUMENT PANEL WIRING HARNESS
(12260287) REPLACEMENT (continued).
18.
b.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Remove wiring harness 12260287 (2) from vehicle.
INSTALLATION
Route wiring harness 12260287 (2) in approximate location of installation.
Connect two wire connector Nos. 400 (42 and 43) behind driver’s instrument panel (48), and wire connector
(40 and 44) top y-connector (45).
Connect wire connector No. 486 (47) to lead assembly 12389711 (46).
Connect wire connector No. 29-31 (53) to fuel gage level switch (54).
Connect wire connector No, 509E (51) to parking brake light (49) on driver’s instrument panel (48).
Connect wire connector No. 486A (52) to glow plug switch (50) on driver’s instrument panel (48).
Connect wire connector Nos. 27B and 14 (34 and 37) to diode harness assembly 12263417 wire connector
Nos. 27B and 14 (35 and 36).
Connect wire connector No. 459 (41 ) to wiring harness 12330252 wire connector No. 459 (40).
Connect wire connector No. 415 (39) to y-connector (38).
Connect wire connector No. 27 (31) to circuit breaker no. 3 (32) on circuit breaker panel no. 1 (33).
Install wiring harness in two retaining straps (30), and secure two retaining straps (30) to driver’s compartment
wall with two screws (27), new Iockwashers (28), and washers (29).
7-171
