TM 9-2350-287-20-1
7-34. RIGHT TAlLLAMP ASSEMBLY REPAIR.
This Task Covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
l General mechanic’s tool kitj (Item 24,
l Vehicle parked on level ground (refer to
Appendix l)
TM 9-2350-287-10).
l MASTER switch set to OFF (refer to
Materials/Parts:
TM 9-2350-287-10).
l Electrical tape (Item 67, Appendix D)
l Battery ground cables disconnected
l Gasket (Item 94, Appendix H)
(para 7-41).
l Lockwasher (2) (Item 177, Appendix H)
Personnel Required: Two
a.
REMOVAL
1.
2.
3.
4.
CAUTION
Be careful not to drop spacers
when removing right taillamp
assembly.
Failure to heed this
caution can result in damage to
taillamp assembly.
NOTE
Taillamp assembly does not have to
be removed to service light-emitting
diodes (LEDs).
Remove four screws (8) and spacers (7) and
cover plate (9) from hull.
Disconnect two electrical leads (6) from wiring
harness (5).
NOTE
An assistant is needed when
removing right taillamp assembly.
Remove two screws (4), Iockwashers (3), and
washers (2) from hull. Discard Iockwashers.
Remove taillamp assembly (1), grommet (10),
and two electrical leads (6) from hull.
7-97
