TM 9-2350-287-20-1
7-35. STEERING SHAFT MASTER WARNING LIGHT REPLACEMENT (continued).
NOTE
Perform steps 4 and 5 only if bracket requires replacement.
4.
Remove cotter pin (13), washer (12), straight pin (7), steering wheel (14), collar (11), and spring (10) from
steering shaft (15). Discard cotter pin.
5.
Remove three screws (9) and Iockwashers (8) and bracket (5) from steering column bracket (16). Discard
b.
1.
2.
3.
4.
5.
6.
Iockwashers.
INSTALLATION
NOTE
Perform steps 1 and 2 only if steering wheel was removed.
Install bracket (5) on steering column bracket (16) with three screws (9) and new Iockwashers (8).
WARNING
Be careful when installing steering wheel. Steering wheel and collar are under spring
tension and may move forward suddenly, causing injury to personnel.
Install spring (10), collar (11), and steering wheel (14) on steering shaft
(15) with straight pin (7), washer (12), and new cotter pin (13).
Install master warning light (3) on bracket (5) with two screws (2) and new self-locking nuts (1).
Apply silicone compound to shells of three electrical connectors (6).
Connect three electrical connectors (6) to master warning light (3).
Install lamp (4) in master warning light (3) by turning lamp (4) clockwise.
FOLLOW-ON MAINTENANCE:
l None
7-101