TM 9-2350-287-20-12-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTIONENGINES (STE/lCE) (continued).b. STE/lCE TROUBLESHOOTING - (continued).(17) VEHICLE OIL PRESSURE - TEST50.Tools/Test Equipment:Equipment Conditions:l General mechanic’s tool kit (Item 24, Appendix I)l Air intake grille opened (refer tol STE/lCE test set (Item 65, Appendix I)TM 9-2350-287-10).. Transmission doors opened (refer toTM 9-2350-287-10).A. 1. Connect DCA cable WI connector P1 toVTM connector J1.2. Connect DCA cable W1 to harness12329996 connector at DCA receptacle indriver’s compartment.3. Push power switch on VTM to ON position.4. Do confidence test 66/99 (para 2-22.a(1)).5. Dial 60 into TEST SELECT.6. Press and release TEST button. Message"VEH” should be displayed on the VTM.7. Enter the vehicle ID number 11.8. Remove 90° elbow from sampling port offitter housing.9. Install blue-striped transducer TK17 andelbow TK26 in sampling port of oil filter mani-fold.10. Connect DCA cable W4 connector P2 toblue-striped transducer TK17.11. Connect connector P1 of harness W4 toVTM.12. Enter 01 into TEST SELECT, then pressand release TEST button.13. When “CON” appears on the VTM, enter50 into TEST SELECT, then press and holdTEST button until “CAL” is displayed on VTM.14. Release TEST button and wait for reading.Reading should be between -150+ 150.15. Press and release TEST button.16. Start engine (refer to TM 9-2350-287-10)and let run until normal operating temperatureis reached (1800).17. Accelerate engine speed to 1000 RPMand record test results.Is reading on VTM between 30 and 50 psi?Fault does not exist as indicated.Recheck fault symptom.Check oil level (refer to TM 9-2350-287-10)and notify Direct Support Maintenance.END OF TASK2-430
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
