TM 9-2350-287-201
2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/ICE) (continued).
.
b. STE/lCE TROUBLESHOOTING - (continued).
(19) STARTER POSITIVE TERMINAL VOLTAGE - TEST
68.
Tools/Test Equipment:
• General mechanic’s tool kit (Item 24, Appendix I)
• STE/lCE test set (Item 65, Appendix I)
A.
1. Connect DCA cable WI connector P1 to
VTM connector J1.
2. Connect DCA cable W1 to harness
12329996 connector at DCA receptacle in
driver's compartment.
3. Push power switch on VTM to ON position.
4. Do confidence test 86/99 (para 2-22.a(1)).
5. Dial 60 into TEST SELECT.
6. Press and release TEST button. Message
"V/EH” should be displayed on the VTM.
7. Enter vehicle ID number 11.
8. Enter 68 into TEST SELECT, then press
and hold TEST button until "CAL” is displayed
on VTM.
9. Press and release TEST button.
10. Crank engine (refer toTM 9-2350-287-10)
while holding fuel shutoff control handle out.
11. Record test results.
Is reading on VTM at least 18 vdc?
Fault does not exist as indicated.
Recheck fault symptom.
Do test 67 (para 2-22b(8)) with control
function 02. If test passes, replace
wiring harness 12329996 (para 7-74).
Verify problem is solved.
END OF TASK
2-432
