TM 9-2350-287-20-12-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTIONENGINES (STE/ICE) (continued).b. STE/lCE TROUBLESHOOTING - (continued).(20) INDIVIDUAL BATTERY VOLTAGE - TEST 89.Tools/Test Equipment:Equipment Conditions:• General mechanic’s tool kit (Item 24, Appendix I)• Battery access doors opened (refer to• STE/lCE test set (Item 65, Appendix I)TM 9-2350-287-10).A. 1. Connect DCA cable W1 connector P1 toVTM connector J1.2. Connect DCA cable W1 to harness 12329996connector at DCA receptacle in driver’s com-partment.3. Push power switch on VTM to ON position.4. Do confidence test 66/99 (para 2-22.a(1)).5. Connect STE/lCE cable W2 connector P1 toVTM connector J4.6. Attach red clip of cable W2 to black clip ofcable W2.7. Enter 89 into TEST SELECT.8. Press and hold TEST button until “CAL” isdisplayed on VTM.9. Press TEST button and wait for offset valueto appear on VTM.10. If offset value is between -6.8 and +6.8,connect red clip of cable W2 to positive termi-nal of battery “A” and black clip of cable W2 tonegative terminal of battery “A”.11. Crank engine (refer to TM 9-2350-287-10)while holding fuel shutoff control handle out.12. Record value displayed while crankingengine.13. Repeat test for batteries B, C, and Done ata time by connecting red clip of cable W2 topositive terminal and black clip of cable W2 tonegative terminal.Is each battery value at least 9.5 vdc?Fault does not exist as indicated.Recheck fault symptom.Check battery electrolyte level (refer to TM 9-2350-287-10). Perform specify gravity checks(Unit PMCS). Replace batteries as required(para 7-41).END OF TASK2-433
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
