TM 9-2350-287-20-12-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTIONENGINES (STE/lCE) (continued).b. STE/ICE TROUBLESHOOTING - CONTINUED(13) FUEL SUPPLY PRESSURE - (DCA AND TK)TEST 24.Tools/Test Equipment:Equipment Conditions:• General mechanic’s tool kit (Item 24, Appendix I)• Air intake grille opened (refer to TM 9-2350-• STE/lCE test set (Item 65, Appendix I)287-10).• Transmission access doors opened (refer toTM 9-2350-287-10).A. 1. Connect DCA cable W1 connector PI toVTM connector J1.2. Connect DCA cable W1 to harness12329996 connector at DCA receptacle indriver's compartment.3. Push power switch on VTM to ON position.4. Do confidence test 66/99 (para 2-22a(1)).5. Dial 60 into TEST SELECT.6. Press and release TEST button. Message“VEH” should be displayed on the VTM.7. Enter the vehicle ID number 11.8. Enter 01 into TEST SELECT, then pressand release TEST button.9. When “CON” shows on VTM, enter 24 intoTEST SELECT, then press TEST button until"CAL” appears.10. Press and release TEST button.11. Crank engine (refer to TM 9-2350-287-10)for 10 seconds while holding fuel shutoff controlhandle out.12. Record test results.13. Release fuel shutoff control handle andstart engine (refer to TM 9-2350-287-10).Record test results.Is reading on VTM between 4.0 and 7.0 psi?Fault does not exist as indicated.Recheck fault symptom.B. Check results recorded during 10-second en-gine crank.Was VTM reading at least 4 psi?Continued on next page2-425
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
