TM 9-2350-287-10
Installing Track (continued)
7.
Stop engine when two track connecting
fixtures can be connected to two track link
pins (2) on both sides of track. Connect
track (p. 3-33).
Connecting Track
WARNING
Track is very heavy. Keep hands and feet from beneath track
while it is being lifted.
1.
Using crowbar, lift track end (1) until it is close enough to other end of track that two track
connecting fixtures can be installed.
2.
Install two track connecting fixtures on track, and tighten until one end connector (2) will
fit over two track link pins (3). If necessary, reposition track connecting fixtures (one at
a time) as shown.
NOTE
Track can be maneuvered by lifting with crowbar or pushing
against inside of track to bow it out.
3.
Maneuver track until end connector (2) can be installed over two track link pins (3) on
inside of track. Tap end connector (2) with hammer to install over two track link pins (3).
Change 1
3-33
