TM 9-2350-287-10AIR CLEANER MAINTENANCE (continued)8. Pull down locking handles (5). Push two air filters (6) in, lift, and pull out from air cleaner box.WARNINGCompressed air used for cleaning purposes should notexceed 30 psi (206.8 kPa). Use compressed air only witheffective chip-guarding and personal protective equipment(e.g., goggles/shield, gloves). Failure to do this may result ininjury to personnel.9.Clean air filters (6) with compressed air. (Emergency cleanby rapping bottom or sides of air filter against flat surface.Do not strike open edge or sealing edge.)10.Clean air filter compartments with damp rags (Item 40,Appendix D).11.Clean air duct into air filter box with damp rags (Item 40,Appendix D) as far as possible.12.Check seal (7) on right and left access doors (4 and 1) fordamage or unserviceable condition. If seal is damaged orin unserviceable condition, notify Unit maintenance.13.Replace air filters (6); aline with outlet gaskets to assureproper sealing, and secure locking handles (5).14.Slide right and left access doors (4 and 1) on air cleaner,and secure doors by pulling locking latch (2) down and thenup.15.Reset air cleaner restriction indicator (8) by pushing up onreset button (located on bottom of cylinder).16.Start engine (p. 2-82). f yellow sleeve in indicator (8) climbsinto red zone, notify Unit maintenance.17.Install right projectile rack assembly (p. 2-1 85)3-28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business