TM 92350-287-10
Removing Track Shoe (continued)
7. Install track connecting fixture on two track link pins (6).
8. Using end connector puller (5), 3/4-inch socket wrench, and 1 1/2 inch socket, remove
end connector (7) from two track link pins (6). If end connectors become cocked during
removal, remove end connector puller (5) and tap end connector (7) with hammer until
end connector (7) is straight on track link pins (6).
Install end connector puller (5), and
continue to remove end connector (7).
9. Repeat steps 5 through 8 on end connector (7) on inside of track.
WARNING
Release tension on track connecting fixtures evenly. Track is
under tension and can move suddenly, causing severe Injury
to personnel.
Change 1
3-36
shoe (2) to track.
Remove two track connecting fixtures from ends of track.
Repeat steps 4,5,6, and 8 on two end connectors (7) securing track
Remove track shoe (2) from track.
