TM 9-2350-277-20-5
REPLACE M3 NBC HOSES AND FITTINGS (M1059A3 ONLY)
0788 00
THIS WORK PACKAGE COVERS:
Removal (page 0788 00-1).
Installation (page 0788 00-5).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Grommet
Lockwasher (23)
Straps (as required)
Personnel Required
Unit Mechanic
References
See your -10
TM 3-6680-316-10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Battery ground strap disconnected (WP 0337 00)
REMOVAL
1.
Loosen clamp (1) and remove hose (2) from connector (3) and adapter (4) on operator’s heater (5).
2.
If damaged, remove adapter (4) from operator’s heater (5).
3.
Remove four screws (6), lockwashers (7), and two brackets (8) from top plate. Discard lockwashers.
4.
Remove three screws (9), lockwashers (10), and clamps (11) from top plate. Remove clamps from operator’s inlet hose
(12). Discard lockwashers.
5.
Cut straps (13) that secure lead 537D (14) to operator’s inlet hose (12). Discard straps.
6.
Loosen clamp (15) and remove operator’s inlet hose (12) from adapter (16) on operator’s heater (5).
7.
If damaged, remove adapter (16) from operator’s heater (5).
0788 00-1
