REPLACE M8A3 NBC HOSES AND BRACKETS (M1059A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_707

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
591

TM 9-2350-277-20-5 REPLACE M8A3 NBC HOSES AND BRACKETS (M1059A3 ONLY) 0787 00 THIS WORK PACKAGE COVERS: Removal (page 0787 00-1). Installation (page 0787 00-4). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Locknut (2) Lockwasher (12) Lockwasher (8) Personnel Required Unit Mechanic References See your -10 TM 3-6680-316-10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground strap disconnected (WP 0337 00) Power plant rear access panel removed (WP 0439 00) REMOVAL 1. Remove smoke generator operator’s hose (1) from connector (2) and two brackets (3). 2. Remove screw (4), lockwasher (5), and connector (2) from support (6). Discard lockwasher. 3. Remove two screws (7), lockwashers (8), and support (6) from vehicle top plate. Discard lockwashers. 4. Remove four screws (9), lockwashers (10), and two brackets (3) from vehicle top plate. Discard lockwashers. 5. Remove smoke generator operator’s hose (1), two screws (11), lockwashers (12), and clips (13) from top plate. Discard lockwashers. 6. Loosen clamp (14) and remove smoke generator operator’s hose (1) from top of transverse beam and disconnect from air purifier (15). 0787 00-1

Privacy Statement
Press Release
Contact